Advertisement
4.2 Assembly Procedures:
Place a bracket chassis base on a protective
S1
cushion.
Turn over a power board and put the power board
S2
into the bracket chassis, locate the panel power
cable into the hook of the bracket chassis.
Take a interface board, connect a LVDS cable to the
connector of the interface board, then connect the
cable of the power board to the connector of the
interface board. Turn over the interface board and
S3
locate it into the bracket. Use a Philips-head
screwdriver to tighten 4pcs screws for locking the
power board and interface board.
(No.1 screw size=M4x8, Torque=5±0.5kgfxcm;
No.2~4 screw size=M3x7.5, Torque=5±0.5kgfxcm)
4
4. Disassembly and Assembly Procedures
3
1
2
Take a mylar to insert the hooks of the bracket to
S5
cover the power board.
The following two steps (S6 and S7) is processed in
LCM assemble line. Take 1pcs function key board
and 1pcs front bezel from the carton, then put the
middle bezel into a fixture, and locate the function
keyboard into the hooks of the front bezel Use a
S6
Philips-head screwdriver to tighten 3pcs screws for
locking the function key board with the front bezel,
then paste 1pcs black mylar tape to cover the
function key board.
(No.1~3 screw size=M2x2.4, Torque=0.8±0.2kgfxcm
Take 1pcs panel module, then put the panel into the
S7
front bezel and locate the panel into the hooks of the
front bezel for the two parts firmly attached.
.
Advertisement
