Page 1
SE2416H 1. Disassembly Procedures: Step Figure Remark Turn off power, S1. The FRONT Unplug external cables VIEW from product To remove the stand: 1. Press and hold the stand release button. 2. Lift the stand up and away from the monitor.
SE2416H Use a Philips-head screwdriver to remove 2 screws for unlocking mechanisms. (No.1~2 screw size=M3x4; Torque=4±1kgf.cm) S3. Remove the REAR COVER Use Penknife to separate the bezel and rear cove follow the arrows in sequence, then you can take out rear cover.
Page 3
SE2416H S6. Remove the FFC cable S7. Remove the tape and panel FFC cable S8. Remove the Remove and turn over it. MAIN FRAME...
Page 4
SE2416H Use a Philips-head screwdriver to remove 5 screws for unlocking mainboard and power S9. Remove the board MAIN &POWER (No.1~4 screw size=M4x8; BOARD Torque= 6±1kgf.cm; No.5 screw size=D3x6; Torque= 6±1kgf.cm) Use a Philips-head screwdriver to remove 4 screws for unlocking Key S10.
Page 5
SE2416H S11. The PANEL Use a Philips-head screwdriver to remove S12. Remove the 1screws for unlocking main frame screw (No.1 screw size= Q3x6 Torque=4±1kgf.cm) S13. The MAIN FRAME S14. The BEZEL...
Page 6
SE2416H Remove electrolyte capacitors (red mark) from printed circuit boards S15.Remove capacitors Take out bulk cap. pin solder with soldering iron and absorber Lift the bulk cap. up and away from the...
SE2416H 2. Product material information The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC. Capacitors / condensers (containing No used PCB/PCT) Mercury containing components...