Maintenance; Guarantee Information - Be Cool CRIB Manual

HOW TO ASSEMBLE THE CRIB CARRYCOT
A: FITTING THE HANDLES:
A. 1. Pass the handles through the two eyelets on the sides as
shown in the photo.
A.2. Pass the tape through the eyelet on the base.
A.3. Fasten the tape on the base.
B: Attach the side of the carrycot with the zip.
Pass the handles through the internal eyelets
C: Fit the mattress base and then the mattress.
Attach the foot cover with the zip.
D:
Fitting the hood.
E:
PRO-FIX SYSTEM
F:
Your pushchair chassis is fitted with the PRO-FIX system,
making it easier to attach and remove the CRIB carrycot from
the chassis, quickly, simply and safely.
G: ATTACHING AND REMOVING THE CRIB CARRYCOT
1. Attaching the Crib carrycot to the chassis: slot the "male" pro
fix system of the Crib carrycot into the profix slots on the
chassis.
2. Removing the Crib carrycot from the chassis: Press the
buttons on both sides and lift the carrycot off the chassis.

MAINTENANCE

Keep the metal parts clean and dry to prevent them from rusting.
Regularly grease the mobile parts and mechanisms with a silico-
ne-based spray. Do not use oil or grease. Just use mild detergent
and warm water to clean the plastic parts. Do not expose the
upholstery to direct sunlight for prolonged periods. The upholstery
can be taken off for washing.

GUARANTEE INFORMATION

This article is guaranteed under the terms and conditions of Royal
Legislative Decree 1 / 2015 of 24 July.
The guarantee does not cover any faults or damage caused by
misuse of the article or by non-observance of the safety and
maintenance procedures listed in the instructions. The receipt
with the date of purchase must be shown to certify the validity of
the guarantee.
EN
15