Linde BOC RAPTOR 160 MIG Operating Manual page 9

DO
✓ Use the correct input current, ✓ cable and
✓ plug in accordance with AS 60974-1 for your
safety and to get the maximum performance
from your welding machine.
Example
If the I rating on your machine is 27A
1eff
then you must use a 32A plug as a 15A
is undersized for the welding current
being used and may cause the cable to
overheat.
How important is the correct input cable and
plug on a welding machine?
The size of the plug depends on a formula that
not only uses the maximum current draw but
also the duty cycle of the power source. The use
of any welding power source will not only cause
the machine itself to heat up, but the input cable,
plug and mains power circuit will increase in
temperature as well. That's why it's important
to understand input and output currents and to
make sure that the input circuit is correctly rated
to supply the required input draw. This allows the
machine to operate at or near maximum output
and protects the circuit board from tripping,
overheating and/or catching fire.
For your safety, BOC meets AS/NZS Standards
for safe electrical compliance.
Regulatory Compliance Mark
(RCM) and number
All BOC welding machines undergo an independent
certification process to meet Australian and New
Zealand regulations regarding electrical safety.
The triangle-circle-tick (RCM) symbol signifies
that BOC has taken the necessary steps to have
the product comply with the electrical safety
and/or electromagnetic compatibility (EMC)
legislative requirements as specified by the
Electrical Regulatory Authorities Council (ERAC).
Depending on the machine, BOC may be required
to have a 32A single phase plug to ensure that
when the machine runs at its maximum output, the
input supply plug and lead will not overheat. For
your safety, please check for this symbol before
buying any welding machine in Australia and
New Zealand.
9