Care And Cleaning; Troubleshooting - HAMPTON BAY HB-7779-02 Use And Care Manual

Operation (continued)
9
Adding a transmitter
Up to two transmitters can be programmed for each
channel. Only one transmitter may be synced at a
time. Repeat these steps for each transmitter.
□
Select the doorbell (A) icon to add a
transmitter.
□
While the icon is flashing, press and hold the
button on the doorbell (A) until the doorbell
sounds a "Beep-Beep".
□
Press the push button (B) or the sync button
on the transmitter within 30 seconds. The
doorbell (A) will sound a "Beep-Beep" tone to
indicate the sensor or the push button (B) is
synced.
□
Test the transmitter or press the push
button (B) as shown in the Installation section
to ensure operation.
Doorbell tune

Care and Cleaning

□
Use a dry cloth to clean these components.
□
Do not use cleaners or polishes.
□
Do not use any fluids on these components.

Troubleshooting

Problem Possible Cause
□
The doorbell does
not sound.
□
□
Front door
push button
Ding-Dong or
Westminster
The batteries are not
installed correctly.
The batteries are dead.
The transmitter(s) and
doorbell are not synced.
Rear door
push button
Ding
Solution
□
Make sure batteries are installed according to the
diagram inside the transmitter(s) and doorbell.
□
Check charge of the transmitter(s) and doorbell batter-
ies and replace if necessary.
□
Sync the doorbell to the transmitter.
□
Follow step 9 under Operation to sync each
transmitter.
12
A
C
RANGE
MAX MIN
TEST 1 5
(MINS)
SYNC
ON-TIME
Motion sensor alert
Beep-Beep, Beep-
Beep, Beep-Beep
B
D
CR2032
Door alert
Beep-Beep