Operation - HAMPTON BAY HB-7779-02 Use And Care Manual

Installation (continued)
12
Mounting the door alert
Use either the small screws (BB) or double-sided
tape (FF) to mount the door alert (D):
□
To mount with the small screws (BB), remove
the back of the door alert (D) by pushing in the
tab on the bottom with a small screwdriver.
□
Place the motion sensor back against the
mounting surface and mark the two screw
holes.
□
Drill two 1/16 in. pilot holes.
□
Attach the motion sensor back with the small
screws (BB). Tighten securely and snap on the
front of the door alert (D).
13
Mounting the magnet
Use the small screws (BB) (or the large screws (CC) if
using the magnet spacer (F)) to mount the magnet (E).
□
Remove the back of the magnet (E) by pushing
in the tab on the bottom of the magnet (E) with
a small screwdriver.
□
Place the magnet back against the mounting
surface and mark the two screw holes.
□
Drill two 1/16 in. pilot holes.

Operation

1
Adjusting the doorbell volume
The doorbell (A) has an adjustable volume control
located on the side. Rotate the thumbwheel up or
down to adjust the volume.
□
When attaching the door alert (D) with double-
sided tape (FF), remove paper from both sides
of the double-sided tape (FF) and apply to a
clean surface.
□
Attach the magnet (E) back with the small
screws (BB). Tighten securely and snap on the
front of the magnet (E).
F
8
BB
D
CC
A