Omega 868F User Manual page 16

Do not touch the elastomer contact strips or mating surfaces
on the PC board. Also, use care when spreading the clips to
avoid breaking them.
5. The instrument may be reassembled by reversing the above
prodcedure, using Figure 5-1 as a guide. When assembling
the instrument, take special note of the following points:
A. If the LCD was removed, be sure it is aligned properly
on the board, with the clips fitted properly into the
notch on each side of the board.
B. If the probe jack was disconnected, make certain the
wires are connected properly. The wire colors are
marked on the PC board.
C. Make sure the PC board is properly secured to the front
case with the standoff. The switch cover should be placed
on the switch when installing the PC board.
D. Once the rear cover is in place, secure it with the
attachment screws.
CAUTION
Figure 5-1. Exploded View
13