Stationary Handle; Movable Handle - Greenlee 776 Instruction Manual

Assembly (continued)

Stationary handle

8. Assemble handle plates (5) to handle unit (39),
but do not tighten hex screws (30).
9. Insert shoulder screws (13 and 16) to align handle
plates (5) and tighten hex screws (30) to 170-190
in-lb. Remove shoulder screws.
5
13
16
30
Greenlee Tools, Inc.
776 Ratchet ACSR Cutter

Movable handle

10. Assemble right and left handle plates (8 and 9) to
handle unit (38), but do not tighten hex screws (31).
Orient handle plates so slotted hole is opposite the
chamfer in the handle adapter.
slot
39
chamfer
11. Install roll pin (34) into right and left handle plates.
12. Install roll pin (33) into speed pawl (11), if necessary.
The roll pin should protrude .20 inches from each
side of the speed pawl.
13. Install spring (35) between handle plates.
14. Spread the right and left handle plates and install
speed pawl so the roll pin fits into the slot in the
handle plates. Use the speed pawl to compress
spring (35).
11
33
15. Insert shoulder screws (13 and 16) to align handle
plates and tighten hex screws (31) to 170-190 in-lb.
Remove shoulder screws.
9
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
9
38
.20"
9
31
8
34
35
38