Operation - Craftsman C459-36426 Operator's Manual

Drive
Control
Blade Control
The blade control is attached to the upper handle of the mower. Depress and
squeeze it against the upper handle to operate the unit. Release it to stop engine
and blade.
This blade control is a safety device. Never attempt to bypass its operation.
Drive Control
The drive control is located on the underside of the upper handle and is used to
engage the drive. Squeeze it against the upper handle to engage the drive; release it
to slow down or stop mower from propelling.
Cutting Height Adjustment Lever
One adjustment lever is located on the right rear wheel and one is located on the
right front wheel. Both levers have to be at the same position to ensure a uniform
cut. To adjust the cutting height, refer to the Assembly Section.
Mulch Plug
The mulch plug is used to recirculate grass clippings back to the lawn. Attach it as
instructed in the Assembly section of this manual.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand behind the unit and
pull the recoil starter rope to start the unit.
Recoil
Starter
Grass
Catcher
Cutting Height
Adjustment Lever
Side Discharge Chute
WARNING

OPERATION

Blade Control
Oil Fill
Fuel Cap
Mulching
Plug
Figure 13
Side Discharge Cover
Your mower is shipped as a mulcher. To discharge the grass clippings to the side
instead, follow the instructions in the Assembly section to attach the side discharge
cover.
Keep hands and feet away from the chute area on cutting deck. Refer to
warning label on the unit.
Trail Shield
The trail shield is attached to the rear of the mower and is there to protect the
operator from flying debris. Do not use the mower unless the shield is fully
functional and in place.
Deck Wash (if equipped)
Your mower's deck is equipped with a water port on its surface as part of its deck
wash system. Use the deck wash to rinse grass clippings from the deck's underside.
Oil Fill Cap/Dipstick
Refer to the separate engine manual.
Fuel Cap
Remove the fuel cap to add fuel.
11
Deck Wash
Cutting Height
Adjustment
Lever
WARNING