Filter Cartridges; Connect System - Brita TITAN PERFOMANCE Professional Installation Manual

INSTALLATION

FILTER CARTRIDGES

1.
Twist the cartridge to lock it into the manifold. (as shown). The Labels on the
manifold will help identifying where the cartridge needs to be twisted and
attached.
STAGE 1
Sediment Filter
FRONT LEFT
1 4
Inlet Tank
22
STAGE 2
Carbon Block Filter
BACK LEFT
The filter elements
are shipped in
their own sealed
packaging. This
will help to simplify
preparation of
the system and
to maximize the
shelf life of the RO
membrane element.
3 2
INSTALLATION

CONNECT SYSTEM

Drain Faucet
1.
Connect 1/4-inch OD
plastic tubing from the
feed water supply source
to the system inlet on the
manifold.
3.
Connect the 1/4" OD
tubing from the air gap
inlet of the faucet to the
concentrate outlet on the
RO manifold.
STAGE 3
Reverse Osmosis Membrane
FRONT RIGHT
NOTE
TITAN REVERSE OSMOSIS
DRINKING WATER SYSTEM
Model Series: BPUSS400 Line Pressure and
BPUSS400BP Booster Pump
Replacement Filters: BPUSF400S,
BPUSF400C, BPUSF400M
System Certified by IAPMO R&T against
NSF/ANSI Standard 58 for the reduction
of Nitrate/Nitrite and Total Dissolved Solids.
2.
4.
STAGE 4
Carbon Block Filter
BACK RIGHT
For conditions of use please see the Performance Data Statement.
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after this filter system.
This system is acceptable for treatment of influent concentrations of
no more than 27mg/L Nitrate and 3mg/L Nitrite in combination
measured as N and is certified for nitrate/nitrite reduction only for
water supplies with a pressure of 344kPa (50 psig) or greater.
Maximum operating temperature 100°F /37.7°C.
Operating pressure 50-100 psi/344-690 kPa.
Please refer to filter cartridge or instruction manual for filter
replacement intervals.
Protect Plus Pro 420 3rd Avenue NW, Hickory, NC 28601
828-449-2536 Service Requests / Product Information
BRITA®PRO Trademark and logo are registered trademarks of
Brita LP and are used under license by Protect Plus, LLC.
All rights reserved.
Data Plate No: 80160116
Connect 3/8-inch OD plastic
tubing from the product
water faucet to
the manifold.
Connect the 3/8" OD
product water tube from
the tank to the manifold.