TESTO 115i Instruction Manual page 9

2.9 Applications
Select "Volume Flow (Outlet)"
2.9.1
Smart Probes: t405i or t410i
Optional: t115i, t510i, t605i, t905i

Timed-average
 Press
 Press
 Can also be done by pressing the button on the Probe
 Press
measured time.
 Press

Parameterization
 Rectangular (Length/Width)
 Round (Diameter)

Select the

Activate/ Deactivate the

Select
 The calculated total volume flow can be added in the report
3. Press

Set your ambient pressure to calculate the right reference value for an accurate
measurement
Select "Volume Flow (Duct)"
2.9.2
Smart Probes: t405i or t510i
Optional: t115i, t410i, t605i, t905i

See (Volume Flow (Outlet)
1. Press
2. Press

Single
 Press
 Press
make another measurement
 Can also be done by pressing the button on the Probe

Multi-point
 Press
appears on the top of the screen.
 Can also be done by pressing the button on the Probe
 After point measurements, click
measurement and get an average result of your point
measurements
 Press
measurement
to start your measurement. Time starts to run on the top of the screen.
to pause your measurement and
to end your measurement. Results are displayed as an average over the
to start a new measurement
of the outlet for volume flow measurement
K-Factor
Funnel factor
Return air or Supply air
and select Pressure setting

see "2.5 Settings view"
and select Edit view
and select Configure measurement
measurement
to make your first measurement
to start a new measurement and again
measurement
to make a first measurement. A small number
to start a new measurement
to continue
in case of a combination with a testovent 415 funnel
to end the