Starter Switch Harness Testing (continued)
60v WPM Service Manual
3429-828 Rev A
g296663
3. Visually inspect the small switches on the circuit board, looking for any
damage or stuck switches. If damaged, replace the switch assembly.
4. Using a digital multi-meter, check the continuity between the board and to
the power head plug.
Note: Remove the outer plug case for easy determination of the pin/wire.
Note: Left switch is the switch furthest away from the board wiring, right
side is closest to the board wiring.
g296542
Figure 24
Figure 25
Page 5–7
Controls: Service and Repairs