Page 1
Form No. 3434-488 Rev A 21in Recycler ® Lawn Mower Model No. 20367—Serial No. 400000000 and Up Model No. 20367T—Serial No. 400000000 and Up *3434-488* A Register at www.Toro.com. Original Instructions (EN)
Troubleshooting ............18 Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready. Figure 1 identifies the location of the model and serial numbers on the product.
The operator of the machine is responsible for Charge the battery pack with only the battery any accidents or hazards occurring to others or charger specified by Toro. A charger suitable for their property. 1 type of battery pack may create a risk of fire when used with another battery pack.
Page 4
Toro [replacement] bag. caution when changing directions on slopes. Do not mow exceedingly steep slopes. Walk, never For best performance, use only genuine Toro run with the machine. replacement parts and accessories. Other replacement parts and accessories could be...
Do not heat the possible special disposal instructions. battery pack above 68°C (154°F) or incinerate SAVE THESE it. Replace the battery pack with a genuine Toro battery pack only; using another type of battery INSTRUCTIONS pack may cause a fire or explosion. Keep...
Page 6
decal137-9462 137-9462 decal137-9463 137-9463 1. The battery pack is charging. 2. The battery pack is fully charged. 3. The battery pack is over or under the appropriate temperature range. 4. Battery pack charging fault decal94-8072 94-8072 decal137-9461 137-9461 1. Battery charge status decal139-8986 139-8986...
Setup Note: The battery pack is not fully charged when it is purchased. Before using the machine for the first time, refer to Charging the Battery Pack (page 13). Mounting the Battery Assembling the Grass Bag Charger (Optional) No Parts Required Parts needed for this procedure: Procedure Mounting hardware (not included)
Unfolding the Handle No Parts Required Procedure WARNING Unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cable(s) when folding or unfolding the handle. • Ensure that the cable(s) are routed to the outside of the handle. •...
Specifications Product Overview Appropriate Temperature Ranges Charge/store the battery pack 5°C (41°F) to 40°C (104°F)* Use the battery pack at -30°C (-22°F) to 49°C (120°F)* Use the machine at 0°C (32°F) to 49°C (120°F)* *Charging time will increase if you do not charge the battery pack within this range.
Operation Before Operation Installing the Battery Pack Important: Operate the battery pack only in temperatures that are within the appropriate range; refer to Specifications (page Make sure that the vents on the battery are clear of any dust and debris. Lift up the battery-compartment lid (A of Figure Line up the cavity in the battery pack with the tongue on the machine and slide the battery pack into the...
Adjusting the Cutting Height Adjust the cutting height as desired. Set all wheels to the same cutting height (Figure g304633 Figure 8 During Operation Starting the Machine Ensure that the battery pack is charged and installed in the machine; refer to Installing the Battery Pack (page 10).
Recycling the Clippings Your machine comes from the factory ready to recycle the grass and leaf clippings back into the lawn. If the grass bag is on the machine, remove it before recycling the clippings. Refer to Removing the Grass Bag (page 12).
LED display indicates the • Replace the blade when necessary with a Toro battery pack is fully charged. Read all safety replacement blade. precautions.
Folding the Handle Indicator Indicates light No battery pack inserted WARNING Green Battery pack is charging Folding or unfolding the handle improperly blinking can damage the cables, causing an unsafe Green Battery pack is charged operating condition. Battery pack and/or battery charger is over or under •...
Page 15
Remove the electric-start button and battery from the machine. Ensure that the cutting-height setting on the machine is 44 mm (1-3/4 inches) or higher; if it is not, raise it; refer to Adjusting the Cutting Height (page 11). Disengage the handle locks (Figure 15).
Maintenance Remove the electric-start button and battery pack from the machine before maintaining or cleaning the machine. Use only the manufacturer’s recommended replacement parts and accessories. Inspect and maintain the machine regularly. Have the machine repaired only by an Authorized Service Dealer.
If you are located outside of the US and Canada, please contact your authorized • Clean all foreign material from the product. Toro distributor. • When not in use, store the machine, electric-start button, battery pack, and battery charger out of the reach of children.
Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair work must be performed by an authorized service center or a similarly qualified specialist if you cannot solve the problem yourself. Problem Possible Cause Corrective Action The machine does not start.
Page 19
Problem Possible Cause Corrective Action It is difficult to remove the battery pack 1. The battery pack/tool is new or there 1. Clean the terminals on the battery and from the tool. is corrosion in the battery terminals the tool. Then apply dielectric grease and/or the terminals on the tool.
Page 20
While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.
Need help?
Do you have a question about the Recycler 20367 and is the answer not in the manual?
Questions and answers