Hopper Lid Switch; Gaskets; Finish; Glass - England's Stove Works 25-PDVC Installation & Operation Manual

This unit is equipped with a hopper lid safety switch (Part # AC-HLSB) which is directly
connected to the top auger motor. In the event the hopper lid is left open while the stove is in
operation, the hopper lid switch will prevent the top auger from turning. This is to prevent byproducts
of combustion from entering the home through the open hopper lid and also to simply prevent
operation with the hopper lid open.
Improper hopper lid safety switch operation will result in a top auger that will not turn and
therefore a stove that will not burn. NEVER place your hand or any object near the auger while the
stove is connected to power.
IMPORTANT: IMPROPER GASKET MAINTENANCE, INCLUDING FAILURE TO REPLACE
GASKETS, CAN CAUSE AIR LEAKS RESULTING IN SMOKE-BACKS. CHECK
GASKETS OFTEN FOR AIRTIGHT SEAL AND REPLACE AS NECESSARY. IT IS
MANDATORY TO REPLACE GASKETS ANNUALLY.
This unit comes with a 3/4" rope gasket around the door that should be replaced annually. To
replace the door gasket (Part # AC-DGKC), the old gasket must first be removed entirely — prior to
adding the new adhesive, you may have to scrape the old cement from the door channel. Once the
cement and gasket have been added, the door should be closed and latched for twenty-four hours to
allow the cement to harden.
If you are replacing the window gasket (Part # AC-GGK), the new gasket will already have
adhesive on one side. Remove the paper on the adhesive side and place the gasket around the
outside edge of the glass by forming a "U" with your fingers and placing the gasket around the glass.
It is important to change the hopper lid gasket if it shows any wear. Be sure to replace the hopper
lid gasket annually, or sooner if necessary.
Note: There is a Combustion Motor Gasket (Part # PU-CBMG), which allows you to remove the
motor from the Combustion Blower housing, clean your stove, and replace the motor and gasket
without having to remove the entire Combustion Blower. However, if you must remove or replace the
entire Combustion Blower, a new blower flange gasket (Part # PU-CBMG) should be added between
the blower flange and the steel exhaust tube.
This new unit has been painted with High-Temperature Paint that should retain its original look
for years. If the unit should get wet and rust spots appear, the spots can be sanded with plain steel
wool and repainted. We recommend this paint, as others may not adhere to the surface or withstand
the high temperatures.
This unit has a 9" x 9" ceramic glass (Part # AC-G9, comes with gasket) in the viewing door.
Surface scratches are acceptable and normal, but if this glass becomes cracked in any area, the unit
should be shut down and the window replaced with this high-temperature ceramic glass.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Hopper Lid Safety Switch

Gaskets

Finish

Glass

20