Table of Contents
Advertisement
1
Overview
Package Contents
Accessories
Power Supplies
Power Supply Status LEDs
Power Protection
The NX-7500 Series Integrated Services Platform lets you centrally administer networks of up to 2,048
WLAN Access Points geographically dispersed over small or medium sized enterprise locations. WiNG
Access Points intelligently handle the traffic flows, quality of service and security at remotely distributed
locations, while the NX-7500 series integrated services platforms provide a single point for
configuration, policy setting, and remote troubleshooting.
Hotspot configuration, security policy management, and statistics aggregation are all done by one
integrated services platform. This efficient WLAN architecture makes controlling the network easier, and
reduces the hardware expense required to support large networks.
Package Contents
An NX-7500 series Integrated Services Platform ships with the following:
•
NX-7500 series Integrated Services Platform
•
Console cable
•
Rack mount brackets
•
NX-7510/NX-7520/NX-7530 Integrated Services Platform Installation Guide (this document)
Accessories
The following accessories are available for NX-7500 series Integrated Services Platform:
•
2 port 10Gb Network Mezzanine Card (NMC) module for use with 10Gb SFP+ transceivers
•
10GbPS short range 850nm multi-mode SFP+ transceiver for use with 10Gb NMC
•
10GbPS long range 10km single-mode SFP+ transceiver for use with 10Gb NMC
•
4 port 10Gb NMC Module for use with 1Gb SFP transceivers
•
1GbPS short range SFP transceiver for use with 1Gb NMC
•
1GbPS long range SFP transceiver for use with 1Gb NMC
•
Spare AC power supply for NX-7510 or NX-7530
•
Spare DC power supply for NX-7510 or NX-7530
•
Mounting kit with sliding rails
•
Spare 500GB hard drive for NX-7530
Additional Recommended Equipment:
•
Standard, grounded 100-240 VAC 50/60 Hz connection
NX-7500 Series Integrated Services Platform
7
Advertisement
Table of Contents
