Advertisement
Available languages
Available languages
R R E E S S U U L L T T
The tool has been unclamped and released.
6 6
C C a a r r e e a a n n d d m m a a i i n n t t e e n n a a n n c c e e
•
Protect the hydraulic chuck against corrosion when stored.
•
Ensure the hydraulic chuck is stored in the unclamped position.
•
The clamping screw is to be cleaned and re-lubricated at regular intervals, depending on the operating and ambient
conditions and in the event of frequent loosening and tightening.
•
If the stop screw for axial tool length adjustment is clamped frequently, it must be cleaned and lubricated at regular in-
tervals.
•
Repairs must only be performed at MAPAL.
•
Instructions for cleaning in a washing facility:
Clean the hydraulic chuck only in the unclamped position.
-
The clamping screw may only be clamped or relieved at room temperature.
-
The washing temperature must not exceed 5 5 0 0 ° ° C C .
-
After cleaning, regrease the clamping screw.
-
By subsequent storage attention is to be paid to corrosion protection.
-
7 7
D D i i s s p p o o s s a a l l
Once the hydraulic chuck reaches the end of its service life, it must be disposed of with due care for the protection of the
environment. The hydraulic chuck can also be sent to MAPAL for proper disposal.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
EN
EN
47
47
Advertisement
