Advertisement
Available languages
Available languages
EN
EN
Adjusting tool length (axial)
W W A A R R N N I I N N G G
I I n n s s u u f f f f i i c c i i e e n n t t c c l l a a m m p p i i n n g g u u p p t t o o t t h h e e s s t t o o p p a a n n d d f f a a i i l l u u r r e e t t o o o o b b s s e e r r v v e e t t h h e e m m i i n n i i m m u u m m n n u u m m b b e e r r o o f f t t u u r r n n s s ! !
Insufficient clamping up to the stop and failure to observe the minimum number of rotations can cause the workpiece to
fly off like a projectile and cause serious injuries.
During clamping, screw in the clamping screw up to the stop, observing the specified minimum number of rotations
section 4.4
(see
44
44
).
I I N N F F O O R R M M A A T T I I O O N N
The stop screw for axial tool length adjustment is not secured to
prevent it from falling out. The specified adjusting range cannot be
exceeded.
Actuation of the stop screw for axial tool length adjustment is pos-
sible from both sides.
Adjust the hydraulic chuck to the tool length by turning the stop screw
for the axial tool length adjustment using an appropriate hex-wrench
with T-handle.
Montage- und Betriebsanleitung
Montage- und Betriebsanleitung
Installation and Operating Instructions
Installation and Operating Instructions
Advertisement
