Table of Contents
Advertisement
Invacare® NordBed™ Essential
4 Accessories
4.1 Side Rails
4.1.1 Installing side rails
WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing,
while assembling or disassembling the side rail.
– Pay attention to your fingers.
– Follow instructions carefully.
– After each assembly, check that all fittings are
properly tightened and that the side rail has
the correct function.
Removable 3/4 length side rails
WARNING!
Risk of entrapment
There's a risk of entrapment or suffocation
between mattress support, side rail and bed
end.
– When using removable side rails, always make
sure that the distance between the bed end
and the side rail's handle upper edge is less
than 6 cm in the head end and more than 32
cm in the foot end of the bed.
4.1.2 Installing the Freya / Embla side rail
WARNING!
Risk of entrapment / suffocation
The user can get trapped or fall out of the
bed if the side rail is not correctly mounted or
damaged.
– Make sure that all gliding shoes are correctly
guided into the bed end guideways.
– Make sure that all side rail bars are above
the locking pin and properly locked.
– Make sure that the straps between the bars
are not damaged or loose.
Mounting
1. Lift the upper bar in one end of the side rail. The
release buttons C must face up/outwards.
2. Press in the locking pin A in the end of the side rail.
8
3. Guide the three gliding shoes B (in the end of the
side rail bars) up into the bed end guideways, until
they have all passed the locking pin D.
4. Repeat steps 2 and 3 to mount the other side of the
side rail.
Dismounting
1. Lower the side rail.
2. Lift the lower bar, in one end, to make the locking
pin D visible and press it in with a pointed object
(e.g. a pencil).
3. Lower all three bars, until they are out of the
guideways.
4. Repeat steps 2 to 3 to dismount the other end of the
side rail.
4.1.3 Installing the Ane side rail
Mounting
1.
Place the mounting clamps of the side rail over the
square tube A , with the release system B at the
head end of the bed.
2.
Tighten the finger screws C to attach the side rail on
the square tube A and make sure it is steady and
fastened.
Dismounting
1. Loosen the finger screws C and remove the side rail.
1657008-A
Advertisement
Table of Contents
