Checking Error Indicators - Epson PLQ-35 User Manual

2. Turn on the printer while holding the F1/Eject and F2 buttons on the control panel.
3. When the Ready light turns on, insert a sheet of A4 paper into the front slot. The printer prints the
version number, and depending on the location, the language selection for the default settings
menu. The selected language is underlined. Select the language by pressing the F1/Eject button.
Press the F2 button to set the language.
4. The printer prints a message asking if you want to print the current settings. Press the F2 button to
start printing. The setting that is currently selected for each item is underlined.
5. Turn off the printer to exit the default setting mode.

Checking Error Indicators

You can identify common printer problems using the lights on the control panel. If your printer stops
working and one or more control panel lights are on or flashing or the printer beeps, use the following
table to diagnose and fix the problem. If you cannot fix your problem using this table, see "Problems
and Solutions" on page 46.
If you cannot fix your problem using this table, see "Problems and Solutions" on page 46.
Note:
The printer beeps once if you press a control panel button when the corresponding function is not
available.
State of Lights
N Power
F Ready
N Offline
N Power
F Ready
N Offline
N Power
F Ready
Beep pattern Problems and Solutions
❏
❏
❏
❏
❏
There can be a variety of causes. It can also be due to your application
software. Contact your administrator for help.
There is no paper loaded in the slot. Load a paper into the front slot.
Paper is not loaded correctly. Remove the paper and reload it
correctly. See "Loading Passbooks" on page 21 or "Loading Single
Sheets" on page 22.
Paper is not fully ejected. Press the F1/Eject button to eject paper or
see "Clearing a Paper Jam" on page 51 for instructions on ejecting
paper.
Paper is jammed in the printer. Clear the paper jam, see "Clearing a
Paper Jam" on page 51 or press the Offline button to clear the error.
The paper size setting may not match the size of the paper you are
using. Check if they match.
PLQ-35 User's Guide
Troubleshooting 45