Table of Contents
Advertisement
HTC 650 E Classic
5.
Fill the tank with cold water.
6.
Connect the water hose to the water connection.
7.
Turn the tap on the machine on to start the water supply.
8.
Turn in the opposite direction to turn the water off.
9.
Turn the tap on the machine's left side to the open position, position 10 Figure 3-1,
page 9.
10.
Turn the tap to the closed position when wet grinding is finished, position 10
Figure 3-1, page 9.
4.8
Operation
The machine's functions can be controlled using on the control panel, see Figure 3-3,
page 11.
During operation, the operator pushes the grinder forwards over the floor surface.
4.8.1
Standby
To activate the machine's functions, turn the ON/OFF knob to the right. When the knob
is in this position, the green Standby light (DUTY) is lit, indicating that the machine is
in standby mode.
4.8.2
Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an emergency, because it
shortens the service life of the machine's electrical components.
When the switch is pressed, all electrically-powered equipment on the machine are
turned off.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies.
Note!
As long as the emergency stop switch is pressed in, the machine cannot be
started. Reset by turning the switch 45° clockwise so that it pops out again. The
machine can then be restarted.
3.0
Operation
19
Advertisement
Table of Contents
