Table of Contents
Advertisement
HTC 650 E Classic
4.2
Handle setting
The appropriate working height is set with the help of the adjustable handle. Release the
handle, by pulling the locking pin on the handle lock, see Figure 3-2, page 10. Adjust
the handle to the desired position and secure it, by inserting the locking pin again.
Figure 4-1. Handle settings
1.
2.
3.
4.3
Handling weights
The machine can be equipped with three weights to make it easy to change the
machine's grinding pressure, seeFigure 4-2, page 14. When all three weights are
mounted, they provide additional grinding pressure that increases the grinding effect.
When using a tool with a high removal rate, such as T-Rex™, we recommend a low
grinding pressure.
Note!
Too high a grinding pressure combined with an incorrect grinding tool may
cause damage to both the machine and the floor.
3.0
Forward position - used during transport, as the machine takes up
significantly less space.
Rear position - used for tipping the machine to make tool replacement easier.
Working position - the working height can be adjusted to two positions using
the machine's adjustable handle.
Operation
13
Advertisement
Table of Contents
