Usb Interface Check; Ringer Sound Check - Sony PCS-G70N Service Manual

4-3-5. USB Interface Check

1. Connect a USB devive, such as a USB mouse, to the unit's WHITE BOARD connector.
n
Connect the USB device before turning on the power of the unit.
2. Refer to Section 4-1-1, and start the terminal software.
3. Disconnect the USB device connected to the WHITE BOARD connector, and check that messages
below are displayed on the terminal PC.
n
Inside < > are examples.
unknown<04.212>[WB init] fnuUsbRhStatusChangeIsrHc()
wb_emur<04.213>[WB init] BSD:fnuDeviceEnumeration()*Enum Start
[WB init] Whiteboard I/F Disconnect!
4. Reconnect the UBS device to the WHITE BOARD connector, and check that messages below are
displayed on the terminal PC.
n
Inside < > are examples. There is no problem with the USB interface even with the error message
"fnuHcdControlTransfer1 ERROR!".
unknown<29.991>[WB init] fnuUsbRhStatusChangeIsrHc()
wb_emur<29.000>[WB init] BSD:fnuDeviceEnumeration()*Enum Start
wb_emur<29.517>[WB init] Whiteboard I/F Connect!
wb_emur<29.528>[WB init] BSD:fnuDeviceEnumeration()
fnuHcdControlTransfer1 ERROR!
5. Disconnect the USB device.

4-3-6. Ringer Sound Check

1. Refer to Section 4-1-1, and start the terminal software.
2. Enter the following command from the terminal PC, and check that the ringer sound comes out.
pcsdb> mail 18,000000003000000a4b0000004b0000000100000001 ↓
3. Enter the following command from the terminal PC, and check that the ringer sound stops.
pcsdb> mail 18,000000003000000a4b0000004b0000000100000000 ↓
PCS-G70N/G70NP/G70NP2
PCS-G70S/G70SP
4-31 (E)