Connecting Inverter Cables; Operating Instructions - DieHard 28.71496 Operator's Manual

6. CONNECTING INVERTER CABLES

The inverter and power source must be in the OFF mode.
IMPORTANT: Make sure you connect your inverter to a 12 volt power supply only.
INVERTER CONNECTION:
NOTE: Determine whether you will be using the battery clips (425 watt output
maximum) or the 12V accessory plug (100 watts maximum).
1. Locate the positive and negative plastic terminals located on the back of the
inverter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw.
Install the negative (black) cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot come loose.
CONNECTING INVERTER CABLE TO A VEHICLE (100 WATTS MAXIMUM):
1. Remove the cigarette lighter from its outlet (if applicable).
2. Push the 12 volt power plug firmly into the outlet.
CONNECTING INVERTER CABLES TO 12V BATTERY OR 12V POWER SOURCE:
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and protective clothing.
3. Connect the positive (red) inverter terminal cable to the power source positive
(+) or battery terminal. Make sure the connection is secure.
4. Connect the negative (black) inverter terminal cable to the power source
negative (-) or battery terminal. Make sure the connection is secure.
5. To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the inverter is being
connected to or disconnected from the 12V power source.
CAUTION: Failure to make the correct connections will result in blown fuses and
permanent damage to the inverter.

7. OPERATING INSTRUCTIONS

1. Connect the inverter (see Connecting Inverter Cables section).
2. Switch the inverter switch to the ON (I) position.
3. The LED indicator light should glow GREEN verifying the inverter is receiving
power.
4. Turn the inverter rocker switch to the OFF (O) position. (The GREEN LED
power indicator light may flash briefly and/or the internal speaker may make a
brief "beep". This is normal.).
5. Make sure the device to be operated is turned OFF.
• 9 •