Installing Enclosure Components; Recommended Tools; Removing And Replacing The Front Bezel - Dell PowerVault MD1000 Hardware Owner's Manual

Installing Enclosure Components

This section explains how to install the following components:
• Front bezel (optional)
• Drives and drive carriers
• EMMs
• Power supplies
• Control panel
• Enclosure midplane

Recommended Tools

The procedures in this section require the use of one or more of the following tools:
• #2 Phillips-head screwdriver
• Torx T10 driver
• Wrist grounding strap, as explained in the safety instructions found in your Product Information
Guide

Removing and Replacing the Front Bezel

To access the drives in your enclosure, you must remove the optional front enclosure bezel. If your
enclosure does not have this bezel, skip this section.
To remove the bezel:
1 If the bezel is locked, insert the bezel locking key in the bezel lock. If the bezel is unlocked, go to
step 3.
2 Turn the key to the left to unlock the bezel.
3 Push inward on the release tab on the bezel and lift it away from the enclosure front (see
Figure 3-1).
Installing Enclosure Components
25