The PowerVault MD1000 supported software and hardware are directly tied to the RAID controller to which it is attached. If a PERC 5/E or PERC 6/E is supported in a server, then the PowerVault MD1000 is supported on that server.
To see a current list of supported servers reference www.dell.com/perc. If a PERC 5/E or PERC 6/E is supported in a server then the PowerVault MD1000 is supported on that server. NOTE: For the latest BIOS information, see the specific server website on support.dell.com.
Supported Operating Systems If a PERC 5/E or PERC 6/E is supported in a server then the PowerVault MD1000 is supported on that server. To determine the latest supported operating system perform the following two steps: 1) Reference www.dell.com/perc 2) Using the info from step one, reference Operating Systems for that platform.
Western Digital (EP500M) SATA 2TB 5.4K RPM Supported Hardware Configurations NOTE: The following MD1000 hardware configurations are supported only on Dell-qualified hardware. There is a limit of two RAID controllers (PERC 5/E and/or PERC 6/E) per PowerEdge server. There is a limit of three MD1000 enclosures per controller port.
Page 9
Figure 1. Supported Hardware Configuration Unified Mode Host controller Host controller Host controller Figure 2. Max Configuration on a Single PERC 5/E or PERC 6/E Controller (both ports connected) Unified Mode The PERC 6/E adapter can detect and use redundant paths to drives contained in an MD1000 enclosure. With redundant paths, if one path fails, another path can be used to communicate between the controller and the hard drive.