Table of Contents
Advertisement
INSTALLATION
POSITIONING THE WASHING MACHINE
The washing machine can be installed as a built-in or
freestanding unit. Place the machine on a fi rm surface
with easy access to the plug.
A. Built-in
The washing machine can be installed under a counter
top with a working height of 850-900 mm. Leave a 5 cm
space around the entire machine, including between the
rear edge of the top cover and the wall behind it.
B. Freestanding
The washing machine can be positioned beside or under
a tumble dryer.
ADJUSTING THE FEET
Keep the noise that the machine produces to a minimum
by adjusting the feet so that the machine is steady and
balanced on the fl oor. Tighten the lock nuts.
CONNECTION TO WATER SUPPLY
Water connection should be carried out by an
appropriately qualifi ed person. Connect the machine
using the accompanying supply hose. Water pressure
should be 0.1–1MPa (approx. 1–10kp/cm2 ; 10–100N/
cm2). There should be a stopcock on the water pipe.
If the pipes are newly installed, it may be wise to fl ush
them through so that any dirt is washed away. Otherwise,
dirt can clog the fi lter in the machine's water intake and
cut off cut off or reduce water fl ow to the machine. Check
for leaks.
20
Locking nut
Use only the supply hose supplied with the machine. Do
not re-use old hoses or other loose supply hoses.
DRAINAGE CONNECTION
The machine is supplied with a drainage hose attached,
which must be connected to a drain. See the examples
below. The height must be 600–900 mm above fl oor level.
The lower position (600 mm) is always preferable. Ensure
that the drainage hose has no kinks.
600--900 mm
The machine can also be connected to the drain via a
spigot connection. In this case the hose should also be
600-900 mm above the fl oor. The internal diameter of the
hole should be at least 18 mm.
• Cut the nipple
• Remove burrs from the hole.
See the illustration.
At least 18 mm
Advertisement
Table of Contents
