Drainage Connection - Asko PROFESSIONAL WMC947PS Operating Instructions Manual

INSTALLATION

DRAINAGE CONNECTION

The machine is supplied with a drainage hose attached,
which must be connected to a drain. See the examples
below. The height must be 600-900 mm above fl oor
level.
The lower position (600 mm) is always preferable.
Ensure that the drainage hose has no kinks.
600-900 mm
The machine can also be connected to the drain via a
spigot connection. In this case the hose should also be
600-900mm above the fl oor. The internal diameter of the
hole should be at least 18 mm.
• Cut the nipple
• Remove burrs from the hole.
See the illustration.
18
At least 18 m
ELECTRICAL INSTALLATION
If the machine is delivered from the factory with a plug
attached it can be connected to an earthed wall socket.
Otherwise, a permanent connection using a multipolar
circuit breaker must be made by a qualifi ed professional.
Connection on delivery
The machine comes with 3-Phase, 400 V, 50 Hz, heat
output 7000 W and fused 16 A. If a residual current
device is being used, this should be type A.
NOTE!
Repairs and maintenance relating to safety or
performance must be carried out by a qualifi ed
professional.