Installation; Drainage Connection - Asko PROFESSIONAL WMC947VS Operating Instructions Manual

INSTALLATION

DRAINAGE CONNECTION

A water outlet hose is included with the machine. This
is attached to the machine's outlet and routed to a fl oor
drain or drainage pipe.
NOTE!
The height of the mouth of the outlet hose must be
lower than the lowest part of the outlet valve.
18
ELECTRICAL INSTALLATION
If the machine is delivered from the factory with a plug
attached it can be connected to an earthed wall socket.
Otherwise, a permanent connection using a multipolar
circuit breaker must be made by a qualifi ed professional.
Connection on delivery
The machine comes with 3-Phase, 400 V, 50 Hz, heat
output 7000 W and fused 16 A. If a residual current
device is being used, this should be type A.
NOTE!
Repairs and maintenance relating to safety or
performance must be carried out by a qualifi ed
professional.
Coin operation
The machine is prepared for coin operation. Such
installation must be carried out by a qualifi ed
professional.
The installation requires a connection cable to power the
coin meter. This connection cable can be ordered using
the factory art. no. 92 090 95.
The coin meter shall be able to short circuit two signal
lines for periods of up to 10 minutes. This is to give the
user time to load the machine, choose a programme and
start the programme after putting the coins in.
"Insert coin" appears on the display when the machine is
started with the main power switch.