Thermostat Installation - Quadra-Fire CAB50-C Installation Manual

D. Thermostat Installation
1. A low voltage thermostat is required to operate this
pellet appliance. You may use the included wall mount
thermostat (Figure 24.1) or purchase an optional
programmable thermostat or remote control. It is
equipped with an adjustable heat anticipator. The
current rating is .05 amps. The anticipator needs to be
adjusted to the lowest setting available.
2. The appliance comes standard with a wall thermostat
and 25 feet of wire. If you need to run more than 25
feet make sure you use a continuous strand of 18 to 22
gauge thermostat wire.
3. When mounting the thermostat to the wall, be sure to
follow your thermostat installation instructions carefully:
a. There is a four (4) screw terminal block located
on the back lower left corner of the stove directly
to the side of the power cord inlet. The center two
(2) screws are for the thermostat wires; attach
thermostat wire to these two screws (Figure 24.2).
b. Separate the body of the thermostat from
the mounting plate by gently pulling the two
pieces apart.
c. Slide thermostat wires through the back of the
mounting plate (Figure 24.3).
d. Connect your thermostat wire to the terminals
(Figure 24.4).
e. Using the hardware included in the box with the
thermostat, screw the backer plate to the wall
(Figure 24.5).
NOTE: Thermostat must be mounted level for accurate
readings. The thermostat should be mounted on
an inside wall approximately five (5) feet up from
the floor and not in direct line with the appliance
convection air.
NOTE: If the thermostat is located too close to the
appliance, you may need to set the temperature
setting slightly higher to maintain the desired
temperature in your home.
f. Snap the thermostat to the cover plate to the
backer plate (Figure 24.1).
Figure 24.1
24
Figure 24.2
Figure 24.3
CAPTIVE
SCREW
Figure 24.4
MOUNTING HOLE
Figure 24.5
7074-803C
Terminal Block
Center 2 Screws for
Thermostat Wires
BACK OF BACK OF
BACKER PLATE BACKER PLATE
HOLES FOR WIRES
UP
CAPTIVE
SCREW
UP
MOUNTING
HOLE
Power Outlet
09/20