reset button
alignment hole
118
Control Panel
Components
The following figure shows the control panel and the location of its
principal connectors and components.
C o n t r o l P a n e l C o m p o n e n t s
hard-drive access
indicator
speaker connector
control-panel cable
Desktop Chassis
•
Removing the control panel
•
Replacing the control panel
Removing the Control Panel (Desktop Chassis)
CAUTION:
Measures."
NOTICE:
Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see
Components" or
Turn off the computer and peripherals, disconnect them from their
1
electrical outlets, wait at least 5 seconds, and then
computer
cover.
Remove the hard-drive
2
chassis intrusion
switch connector
screw hole
Before you perform this procedure, see
"Interior Service
Label."
bracket.
hard-drive thermal sensor
connector
(mini tower chassis only)
power indicator
power button
"Precautionary
"System Board
remove the