Removing A Hard Drive (Desktop Chassis) - Dell Precision 330 Service Manual

Rotate the power supply back into position until the securing tab
7
snaps into the release latch.
Replace the computer cover and
8
If the drive you installed is a hard drive, enter system setup, and
9
update the drive settings.
After you update the system settings, exit system setup and reboot the
computer.
If the device you installed is a hard drive, partition and logically format
10
the drive before proceeding to the next step.
See the operating system's documentation for instructions.
Test the drive to verify that it is operating properly.
11
• If the drive you installed is a hard drive, run the Dell Diagnostics
to test the drive.
• For other types of drives, see the drive's documentation for
information on testing the drive.
If the drive you installed is the primary hard drive, install the operating
12
system on the drive.
See the operating system's documentation for instructions.
NOTE:
Tape drives sold by Dell come with their own operating software
and documentation. After you install a tape drive, refer to the
documentation that came with the drive for instructions on installing and
using the tape drive software.

Removing a Hard Drive (Desktop Chassis)

CAUTION: Before you perform this procedure, see
Measures."
NOTICE:
Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see
Components" or "Interior Service
Turn off the computer and peripherals, disconnect them from their
1
electrical outlets, wait at least 5 seconds, and then
computer cover.
Rotate the power supply
2
restart the system.
Label."
away from the system board.
"Precautionary
"System Board
remove the
D i s k D ri ve s a n d M e d i a
73