Routing Diagram - True FS-53 Assembly Manual

C R
ABLE EPLACEMENT
Cables should be replaced at the first sign of wear or on an annual basis. Both cables on this
machine should be replaced at the same time. Use only genuine TRUE cables.
Please refer to the following diagram when replacing the cable to insure that it is properly routed.
Take special care to make sure that it is not routed under the bolts for the vertical frame member
and not routed around any cable retention pins.
& C R
ABLE OUTING
IMPORTANT!
When installing Lat Cable, first remove
these frame bolts, route both cables,
pull the cables tight so that the lat cable
is above the bolt holes, then reinstall the
bolts.
26
D
IAGRAM