Dell Dimension 8100 Solution Manual page 51

CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
You can increase your computer memory by installing memory modules on
the system board. See page 61 for information on the type of memory
supported by your computer.
NOTICE:
If you upgrade the memory, the RIMMs must be upgraded in
matched pairs of identical MB capacity in both sockets 1 and 2 or sockets 3
and 4.
NOTICE:
Be sure to install RIMMs in the first two sockets nearest the
processor before installing RIMMs in the outer two sockets.
Remove the computer cover (see page 40).
1
Rotate the power supply.
2
Free the power supply from the securing tab by pressing the release
tab. Then rotate the power supply upward until it locks in its extended
position.
Press out the securing clip at each end of the memory connector.
3
Align the notches on the bottom of the module with the crossbars in
4
the connector.
NOTICE: To avoid breaking the memory module, do not press near the middle
of the module.
Adding Pa rts 51