Dell Dimension 8100 Solution Manual page 46

46
Adding Parts
To replace the front panel, fit the two retaining hooks into the recessed slots
at the bottom of the computer (see the preceding illustration), and then
rotate the top of the panel toward the computer until the tabs snap into the
slots on the panel.
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
The computer has the following slots for the following cards (see page 43):
• Up to five 33-MHz 32-bit PCI cards.
• One 32-bit AGP card. The slot supports AGP 4x or 2x modes operating
at 1.5-V.
CAUTION: Before connecting a peripheral to the computer or
adding a component to the system board, verify that the standby
power LED on the system board (see page 43) is off.
32-bit PCI
card
card
bracket
32-bit AGP
4x card
card
bracket