Dell Dimension 8100 Solution Manual page 49

CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
Turn off the computer and devices, disconnect them from their
1
electrical outlets, and press and release the power button to drain the
power from the computer. Wait at least 5 seconds, and then remove
the computer cover (see page 40).
If necessary, disconnect any cables connected to the card.
2
Remove the screw that secures the card bracket to the computer.
3
Grasp the card by its top corners, and ease it out of its connector.
4
If you are removing the card permanently, install a filler bracket in the
5
empty card-slot opening, using the screw you removed in step 3.
Replace the computer cover, reconnect the computer and devices to
6
their electrical outlets, and turn them on.
If you removed a sound card, enter the system setup program (see
7
page 64), select Integrated Devices, and change the setting for Sound
to On.
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
Turn off the computer and devices, disconnect them from their
1
electrical outlets, and press and release the power button to drain the
power from the computer. Wait at least 5 seconds, and then remove
the computer cover (see page 40).
HINT: Installing filler
brackets over empty card-
slot openings is necessary
to maintain FCC
certification of the
computer. The brackets
also keep dust and dirt out
of your computer.
Adding Pa rts 49