Dell Dimension 8100 Solution Manual page 44

44
Adding Parts
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 7.
To access some of the components on the system board, you may need to
rotate the system power supply out of the way:
Turn off the computer and devices, disconnect them from their
1
electrical outlets, and wait at least 5 seconds. Press and release the
power button to drain the power from the computer, and then remove
the computer cover (see page 40).
Make sure that the power cable is disconnected from the power
2
receptacle on the back of the power supply.
Free the power supply from the securing tab by pressing the release
3
tab. Then rotate the power supply upward until it locks in its extended
position.
power supply
power cable
securing tab
release tab