Dell Dimension 4400 Owner's Manual page 80

HINT:
Your computer
uses cable-select drive
cables. This means that
the device connected to
the end connector of the
drive cable is the master
device and the device
connected to the middle
connector is the slave
device. Be sure that the
jumper setting on the new
device is set for "cable
select" (see the
documentation that came
with the drive for
information).
80
Adding Parts
Locate the extra connector on the drive cable that is attached to your
11
first hard drive and attach the connector to the second hard drive.
power cable
Close the computer cover (see page 87).
12
Connect your computer and devices to their electrical outlets, and
13
turn them on.
NOTICE:
To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
See the documentation that came with the drive for instructions on
14
installing any software required for drive operation.
second hard-drive
cable (secondary
drive)
first hard-drive
cable (primary
boot drive)