To remove the card, grasp the card by the top corners and lift it out.
7
If the card is difficult to remove, gently ease the card back and forth to
remove it from the connector.
securing lever
filler bracket in empty
card-slot opening
back of computer
If you are not replacing the card, install a filler bracket in the empty
8
card-slot opening.
If you are adding a card, see page 69.
Lower the securing lever.
9
Close the computer cover (see page 87).
10
Connect your computer and devices to their electrical outlets, and
11
turn them on.
NOTICE:
To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
card
slot connector
system board
HINT:
The AGP card is
removed from the
following illustration to
provide a better view of
the inside of your
computer.
HINT:
Installing filler
brackets over empty card-
slot openings is necessary
to maintain Federal
Communications
Commission (FCC)
certification of the
computer. The brackets
also keep dust and dirt out
of your computer.
Adding Pa rts
73