Axis P1455-LE User Manual page 15

AXIS P1455-LE Network Camera
Additional settings
Set up intrusion alarm
Before you start
• Connect the intrusion alarm switch to pin 1 (ground) and pin 3 (digital input) of the camera's I/O connector.
Configure the input port
1. Go to Settings > System > I/O ports.
2. For Port 1:
2.1 Select Closed circuit (NC) in the drop-down menu
Create a rule
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under I/O, select Digital input.
4. In the list of ports, select Input 1.
5. In the list of actions, under Notifications, select Send notification to email.
6. Select a recipient from the list or go to Recipients to create a new recipient.
To create a new recipient, click
7. Type a subject and a message for the email.
8. Click Save.
Send an email automatically if someone spray paints the lens
1. Go to Settings > System > Detectors.
2. Turn on Trigger on dark images. This will trigger an alarm if the lens is sprayed, covered, or rendered severely out of focus.
3. Set a duration for Trigger after. The value indicates the time that must pass before an email is sent.
Create a rule:
1. Go to Settings > System > Events > Rules and add a rule.
2. Type a name for the rule.
3. In the list of conditions, select Tampering.
4. In the list of actions, select Send notification to email.
5. Select a recipient from the list or go to Recipients to create a new recipient.
To create a new recipient, click
6. Type a subject and a message for the email.
. To copy an existing recipient, click
. To copy an existing recipient, click
15
.
.
.