Axis P1455-LE User Manual page 13

AXIS P1455-LE Network Camera
Additional settings
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and to
stop one minute after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
1. Set up the stream profile to include audio, see Add audio to your recording on page 16.
Turn on audio detection:
1. Go to Settings > System > Detectors > Audio detection.
2. Adjust the alarm level according to your needs.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Audio, select Audio Detection.
4. In the list of actions, under Recordings, select Record video.
5. Select the stream profile where audio has been turned on.
6. Set the prebuffer time to 5 seconds.
7. Set the postbuffer time to 60 seconds.
8. In the list of storage options, select SD card.
9. Click Save.
Record video when the camera detects impact
Shock detection allows the camera to detect tampering caused by vibrations or shock. Vibrations due to the environment or to an
object can trigger an action depending on the shock sensitivity range, which can be set from 0 to 100. In this scenario, someone is
throwing rocks at the camera after hours and you would like to get a video clip of the event.
Turn on shock detection:
1. Go to Settings > System > Detectors.
2. Turn on shock detection, and set a value for the shock sensitivity.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Device status, select Shock detected.
4. Click + to add a second condition.
5. In the list of conditions, under Scheduled and recurring, select Scheduled event.
6. In the list of schedules, select After hours .
7. In the list of actions, under Recordings, select Record video while the rule is active.
13