Delfield KH-2 Specifications

Short Form

Specifications

Exterior Body is seamless, one-piece
molded fiberglass, having perfectly
smooth exterior surface with all cor-
ners fully rounded. The fiberglass rein-
forced polyester (F.R.P.) is molded with
permanent color. Stress points are
internally reinforced.
Exterior top is constructed of 14-gauge
stainless steel, welded, ground and pol-
ished into one integral unit. Top is
fabricated with square exterior corners.
Top has two to six electrically heated,
recessed, die-stamped stainless steel hot
food warmers. Each warmer accommo-
dates one 12.75" x 20.75" x 6" (32.4cm x
52.7cm x 15.2cm) pan.
Heated food warmers are constructed
of die-stamped stainless steel. Heated
food warmers are insulated on bottom.
Each heated food warmer is individually
equipped with a heated element rated at
1000 watts for 120 volt or 208/230 volt,
60 hertz, single phase service and wired
to an adjustable control switch and indica-
tor light in the control panel. Heated food
warmers are interwired to a minimum 10'
(3m) long cord with a grounded plug for
120 volt or 208/230 volt, 60 hertz, single
phase electrical service.
Casters: Unit is mounted on 5" (12.7cm)
diameter swivel casters with non-marking
polyolefin tires and plate brakes. Overall
height of caster assembly is 6.00"
(15.2cm).
The following applies
to KH Series
only.
All KH models have a one door heated com-
partment. Compartment is constructed of
22-gauge stainless steel, is insulated with a
minimum of 2" (5.1cm) insulation and
is provided with removable 16-gauge pan
slides. KH-2 comes with a single capacity
heated compartment; compartment holds
four 12.75" x 20.75" x 2.5" (32.4cm x 52.7c,
x 6.4cm) pans. KH-3, KH-4, KH-5 and KH-6
units come with double capacity (single door)
heated compartment with a center partition;
compartment holds eight 12.75" x 20.75"
x 2.5" (32.4cm x 52.7c, x 6.4cm) pans.
The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.
With the center partition removed the double
capacity compartment can hold four 18" x
26" (45.7cm x 66cm) sheet pans. The inter-
nally mounted heating element is rated at 890
watts, has a louvered protective cover and
is wired to a temperature control thermostat
and indicator light in the stainless steel con-
trol panel. Doors are built with double-wall
construction, with gaskets and stainless steel
front panel.
Optional Accessories and
Modifications:
A) 12" (30.5cm) wide stainless steel
fold-down tray slide
C) 10" (25.4cm) wide three-bar fold-
down tray slide
D) 10" (25.4cm) wide composite fold-
down cutting boards
E) 10" (25.4cm) wide stainless steel
fold-down work shelf
F) Line-up interlock device
G) Glass-front counter protector
H) Two tier display with glass shelves
and sneezeguards
HD) Dual service two tier display with
sneezeguards
I) Three tier display with glass shelves
and sneezeguards
J) 12" (30.5cm) wide 18-gauge stain-
less steel overshelf
KS) Single service flip-up sneezeguard
KD) Double service flip-up sneezeguard
LI) *Incandescent light fixtures
M) *Radiant heat lamps
MB) *Bullet-style heat lamps
P) Open understorage with shelf
(KH-NU Series only)
Q) *120V/60Hz/1ø, 10 amp conve-
nience outlet with breaker
QQ) Drains from food wells, plumbed to
common valve
SG5A) Single dry insert with doors (KH-NU
Series only)
SG5B) Double dry insert with doors
(KH-NU Series only)
ST) Stainless steel trim strips
U) 14" x 30" (35.6cm x 76.2cm) stain-
less steel end drop shelf
UU) Molded fiberglass trim strips
V) 6" (15.2cm) high adjustable
stainless steel legs in lieu of
casters
*Inclusion of these options will alter the elec-
trical specifications of unit.
PROJECT
ITEM #
QUANTITY
APPROVAL
KH & KH-NU
Mobile Heated Serving Counters
Model KH-3
shown with option A and G
Model KH-4-NU
shown with option G and P
DATE