Fimco Volt Edge 20V-30-2N-TRL Owner's Manual page 12

Remote Button Identification:
The small LED at the top of remote turns red when transmitting.
The red LED is also the pairing button.
The 'ON' button will only turn on the Volt Edge Receiver.
The 'OFF' button will only turn off the Volt Edge Receiver.
Pairing Procedure:
1. Ensure the receiver power cord is not connected.
2. Install a charged battery pack into the receiver.
3. Power ON the Volt Edge receiver. Within 15 seconds press and hold the pairing button for 5 seconds. The green LED on the receiver
will quickly turn off and back on when pairing is successful.
4. Power OFF the Volt Edge receiver.
5. Power ON the Volt Edge receiver and press the OFF and then ON button to confirm pairing is successful.
Storage Recommendations:

The best storage place is one that is cool and dry, away from direct sunlight and excess heat, cold or moisture.
Remote Capabilities:

The remote can control the receiver up to 50 feet away. Obstructions and radio interference can reduce the effective distance.

A remote can be paired to multiple receivers at one time.

A receiver can only be paired to one remote at a time.

A receiver/remote relationship can only be separated by pairing with another remote.
FCC WARNING:
Please note that changes or modifications of this product is not expressly approved by the party responsible for compliance, could void the user's
authority to operate the equipement.
FCC STATEMENT:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
readiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi-
cations.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
Exploded View/Parts List
20V, 5A
Lithium Battery Kit (5281506)
Page 12
Declaration of Conformity:
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including inter-
ference that may cause undesired operation.
TROUBLESHOOTING
Problem Possible Cause
Charger
not plugged in
Temperature is
Battery
too hot or too cold
will not charge
Battery pack not inserted
into charger
Remote battery is
discharged
Remote
Receiver is not on
does not control the
receiver Remote is not
paired with receiver
Radio Interference
Receiver does not
Battery not connected
power pump &
green LED is off Battery discharged
Bad electrical
Receiver does not
connection
power pump &
green LED is on
Pump fuse is blown
Possible Solution
Plug charger into a working outlet.
Check outlet with another device.
Move charger and battery to a climate-controlled environment and wait for
the product to reach room temperature.
Remove battery pack and re-install battery pack. Ensure the bottom edge
of the battery is seated first, then push the clips in.
Replace the battery with CR2032 size button cell battery.
The green light must be illuminated on the receiver for the remote to control
it.
Follow the Pairing Instructions to pair a remote and receiver.
Move the receiver and remote away from the electronic interference.
Remove battery pack and carefully reinstall.
Remove battery, charge and reinstall.
Follow wires from receiver to plug. Disconnect and reconnect
2-pin plug.
Check fuse on pump wire and replace if necessary.