Table of Contents
Advertisement
Timer Mode
●
The second hand, and the small hour and
minute hands indicate the current countdown
time.
The main hour and minute hands indicate
●
the current time.
①
Reset
Start/Stop
② ③ ④
Timer seconds
A
Timer hours
B
Timer minutes
C
Timer hours (24-hour time)
D
The hand points to the A-side for hours 0
through 12, and to the P-side for hours 12
through 24.
Alarm Mode
●
The small hour and minute hands indicate the
alarm time.
The second hand indicates the alarm enabled/
disabled setting.
The main hour and minute hands indicate
●
the current time.
①
Hand Shift
Enabling/
Disabling the Alarm
② ③ ④
Alarm enabled/disabled
A
Alarm hour
B
Alarm minute
C
Alarm hour (24-hour time)
D
The hand points to the A-side for a.m.
times, and to the P-side for p.m. times.
Operation Guide 5623
Using the Crown
The watch's crown is a screw-in (screw lock)
type. To use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
Important!
To prevent loss of water resistance
●
and/or damage due to impact, be sure
to screw the crown in by rotating it
away from you as you push it in.
When pushing the crown back in, take
●
care not to apply too much force.
Fast Forward/Fast Reverse
●
Crown
Normal timekeeping
After pulling out the crown to the first or second
click, rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
Stopping Fast Forward/Fast Reverse
●
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Crown
Loosen
Screw in
Second click
First click
Hand and Day Indicator
Movement
Mode hand
Day indicator
Mode Hand and Day Indicator
●
Movement
Changing the day setting of the watch will also
cause the mode hand to move.
Day
●
It can take anywhere from about 10 to 40
●
seconds for the day indicator to change
after timekeeping reaches midnight. The
mode hand moves as the day indicator
changes.
The day may not be indicated correctly
●
while the watch's crown is pulled out.
Shifting the Hands
Hand shift moves the hands out of the way for
easy viewing of display info.
1.
Press (A).
This will shift the hands to allow easier
●
reading of face information.
2.
To return the hands to their normal
timekeeping positions, press (A) or (D), or
press (C) to change to another mode.
Note
If you leave the watch with its hands
●
shifted and do not perform any
operation for about ten seconds, the
hands will resume normal timekeeping
automatically.
4
Advertisement
Table of Contents
