Table of Contents
Advertisement
Signal Reception Precautions
When the watch is unable to adjust its time
●
in accordance with a calibration signal for
some reason, average timekeeping
accuracy is within ±15 seconds per month.
Note that an internal decoding process the
●
watch performs after it receives a signal
may cause the time setting to be slightly off
(by less than one second).
Time calibration signal reception is not
●
possible under the conditions described
below.
While battery power is low
ー
In any mode besides the Calendar Mode
ー
While the watch is at Level 3 power
ー
saving
While the crown is pulled out
ー
While a timer countdown operation is in
ー
progress
While the Home City setting is a time zone
ー
where time signal reception is not
possible
While the watch is outside the time signal
ー
reception range
While the Airplane Mode is enabled
ー
When the receive operation is successful,
●
the time and/or day settings will be adjusted
automatically. Summer time will not be
applied correctly in the case described
below.
When the summer time start date and
ー
time, end date and time, or other rules are
changed by authorities
If your watch is connected with a phone,
●
settings must be configured so G-SHOCK
Connected can acquire location
information. Even if you are in an area that
is within the reception range of a time signal,
reception will not be performed if settings
are configured in a way that makes signal
reception impossible.
As of January 2020, China does not
●
observe summer time. If China starts to
observe summer time in the future, the time
displayed by the watch for China may not be
correct.
Operation Guide 5623
Using Watch Operations to
Adjust the Time Setting
If your watch cannot connect with a phone for
some reason, you can use watch operations
to adjust date and time settings.
Selecting Your Home City's Time Zone
●
Use the procedure in this section to select the
time zone of the city you want to use as your
Home City.
Important!
If you do not specify the time zone
●
where you are using the watch, the
current time setting will not be correct
after it is adjusted based on a time
calibration signal.
1.
Loosen the crown and then pull it out to the
second click.
The second hand indicates the currently
selected time zone, while the mode hand
indicates the current summer time setting.
The time zone is indicated as a time
●
offset. ±0 hours is indicated when the
second hand is at 12 o'clock, with other
offsets indicated when it is to the left and
right of 12 o'clock. For information about
time zone positions, go to the section
below.
City (Time Zone) List
l
Tokyo (+9 offset)
Time zone (9 position)
Summer time setting
2.
Rotate the crown to change the time zone.
3.
Push the crown back in and then lock it.
Adjusting the Time and Day Setting
●
1.
Loosen the crown and then pull it out to the
second click.
The second hand will point to the currently
selected time zone.
The mode hand will point to the summer
●
time setting for the currently selected
Home City.
2.
Hold down (C) for at least one second.
This causes the second hand to move to
12 o'clock, and enables the minute setting
operation.
3.
Rotate the crown to change the minute
setting.
4.
Press (C).
The hour hand will move slightly,
indicating that the hour setting operation
is enabled.
5.
Rotate the crown to change the hour
setting.
6.
Press (C).
This enables the year ten's digit setting
operation.
7.
Rotate the crown to move the second
hand to the desired setting for the year
ten's digit.
Crown
8.
Press (C).
This enables the year one's digit setting
operation.
Time zone
Crown
Summer time setting
Year (10's digit)
00
10
20
90
30
80
40
70
50
60
9
Advertisement
Table of Contents
