Pioneer VREC-DZ600 Owner's Manual page 15

1 Clean the installation area of dirt and oils using the included cleaning cloth.
2 Install this product.
① : Set the mounting bracket on this product.
② : Peel off the double-sided tape release paper from the mounting bracket.
③ : Install at the specified position of the front windscreen.
CAUTION
• Make sure that the surface of the front windscreen is dry before applying the tape.
• Firmly push the area around the LCD. Next, remove this product from the mounting bracket, directly
press the mounting bracket against the tape. In this way, the product can be firmly installed on the
windscreen.
• Never touch the surface of the LCD.
• Use extreme care as the double-sided tape on the mounting bracket is extremely strong, and it will be
difficult to reapply the tape once it has been applied.
• To ensure the installation strength of the adhesive tape, leave this product for 24 hours after application
before using it.
• Install firmly so that it does not come off. Incorrect installation may cause this to peel off while driving
and cause an accident. Inspect the installation state from time to time.
3 Route the cable.
Route the power cable to the passenger seat side.
Connect the power supply depending on its type. →
4 Turn the vehicle engine on to display the recording screen.
1
2
"Connecting the Power Cable"
− 15 −
Front
Windscreen
3
Firmly push
this product.