King Industrial KC-1402FX Instruction Manual page 8

ALIgNINg FENCE RAIL
1) The left side "zero" mark on the ruler of the fence rail (A) Fig.8 must be aligned
with the blade. Slide rip fence up against the blade, lock the fence by lowering
the fence lock handle.
2) Reposition the fence rail (A) Fig.8 so the zero mark aligns with the indicator line
(B) of the rip fence window (C).
3) Secure the guide rail by tightening the four lock knobs (B) Fig.6 under the table.
INSTALLINg MITER gAUgE
1) Place the t-slot bar of the miter gauge (A) Fig.9 into the miter gauge slot (B) in
the table on the right side of the blade.
2) To adjust angle of miter gauge, loosen lock handle (C) Fig.9 and rotate gauge
body. Tighten lock handle.
INSTALLINg PUSH STICk STORAgE HOOk
1) Thread storage hook (A) Fig.10 into the top left side of the bandsaw frame.
Secure hook by tightening hex. nut (B) up against the frame.
2) Position push stick (C) Fig.10 on storage hook.
INSTALLINg CIRCLE CUTTER
1) This Bandsaw comes with a circle cutter attachment, see Fig.11. Insert center
pin (A) into the sliding bracket (B). Secure center pin with lock knob (C).
2) Slide the shaft of the sliding bracket (B) into the bearing bracket of the upper
blade guide assembly. Slide it to the desired position and secure it with lock
knob (D).
For operation instructions see section "Operation".
ASSEMBLY
FIgURE 8
FIgURE 9
FIgURE 10
FIgURE 11