Table of Contents
Advertisement
100519 - 6250W OPEN FRAME INvERTER
5. Plug in and turn on the next item.
6. Allow the engine to stabilize.
7. Repeat steps 5-6 for each additional item.
Never exceed the specified capacity when adding loads to
the generator.
GFCI
Your generator is equipped with ground fault circuit interrupter
(GFCI) receptacles. In the event of a ground fault, a GFCI trips
automatically to stop the flow of electricity and prevent serious
injury. The green indicator light (A) on the receptacle will also
turn off. Press the "RESET" (B) button located on the front of
the receptacle to restore flow of electricity. The indicator light
will also turn back on. GFCI does not protect against circuit
overloads.
To ensure proper operation of the GFCI duplex, perform this test
monthly:
1. With the generator running, plug a lamp into the GFCI
receptacle. Turn the lamp on.
2. Press the "TEST" (C) button located on the front of the
receptacle to trip the device. This should immediately
stop the flow of electricity and shut off the lamp. If the
electricity is not stopped, do not use this receptacle until is
has been serviced or replaced.
3. Press the "RESET" button located on the front of the
receptacle to restore the flow of electricity. If the indicator
light does not come back on or if the GFCI cannot be reset
then it must be replaced.
A
b
Eco (Economy) Mode
The Eco Mode switch can be activated to turn on economy
control in order to minimize fuel consumption and noise while
operating the unit during times of reduced electrical output. Eco
Mode allows the engine speed to idle during periods of non-use.
The engine speed returns to normal when an electrical load is
connected. When the economy switch is off, the engine runs at
normal speed continuously.
NOTICE
C
Eco Mode ON
Eco Mode OFF
For periods of high electrical load or momentary
fluctuations, the Eco Mode should be off.
12v DC Automotive Style Outlet
The 12V DC outlet(s) can be used with the supplied accessories
and other commercially available 12V DC automotive style
plugs. The DC output is unregulated and can damage some
products. Confirm the input voltage range of your item is at
least 12-24V DC. When using the DC outlet turn the Eco Mode
switch to the "OFF" position.
Do not operate a device while it is plugged in to the 12V DC
outlet.
Prolonged exposure to engine exhaust can cause serious
injury or death.
While charging a device do not place on the exhaust side of
the generator. Extreme heat caused by exhaust can damage
the device, and cause a potential fire hazard.
21
OPERATION
CAUTION
WARNING
CAUTION
Hide quick links:
Advertisement
Table of Contents
