Mold Control Operation; Timer Operation - Sharp DW-J27A Operation Manual

OPERATION

MOLD CONTROL OPERATION

This mode is used to suppress the mold through
strong air fl ow with Plasmacluster Ion.
When turned ON, it fi rstly starts ventilation for 10
minutes with maximum air fl ow, and then repeats
following operation.
(Cleanliness monitor shows actual operating mode.
Purple: high air volume, Blue: low air volume.)
It operates automatically the Plasmacluster Ion
"ON".
In a high humidity
It operates in "HIGH" mode of dehumidifi cation
until the humidity of the room decreases to
the level which the mold less likely appears.
In a low humidity
Once the humidity in room becomes low, the
model switches the operation with maximum
airfl ow.
【 for about 80 minutes 】
(Cleanliness Monitor: blinking with Purple)
※ Operating time depends on the room environment,
usage conditions, and location of the Main Unit.
NOTE
• When the air in the room is purifi ed and the humidity
becomes low, the main unit operates with "Low" air
fl ow. (Cleanliness Monitor : lighting in Blue)
If the humidity becomes high again, it will switch to
the above operation under the condition of "in a high
humidity".

TIMER OPERATION

ON TIMER
The Main Unit automatically starts once the
selected time passes.
(with the Main Unit OFF)
♪ ♪
1hour 2hour
After 8 seconds, the beep sounds.
OFF TIMER
The Main Unit automatically stops once the
selected time comes.
(with the Main Unit ON)
♪ ♪
1hour 2hour
After 8 seconds, the beep sounds.
EN-8
Front Display
♪ ♪
......
3hour 12hour Cancel
Front Display
♪ ♪
......
3hour 12hour Cancel
♪ ♪
♪ ♪