Laundry Operation; Internal Dry Operation; Mold Control Operation - Sharp DW-P22A Operation Manual

OPERATION

LAUNDRY OPERATION

DRY(AUTO) :
When you want to dry with less power
consumption, the Main Unit will repeat the
Dehumidifying operation and the Air Flow mode
to dry the laundry.
DEODORIZE :
When you want to deodorize your laundry, the
Main Unit operates at "HIGH" fan speed.
Make sure the air blowing out from air outlet is
directed to your laundry.
You cannot select the Plasmacluster Ion "OFF".

INTERNAL DRY OPERATION

When you set the Internal Dry operation, the Main
Unit automatically operate the Air Flow mode for
approximate 90 minutes after stopping.
(with the Main Unit ON)
♪
♪
♪
♪ ♪
more 3 sec.
EN-6

MOLD CONTROL OPERATION

This mode is used to suppress the mold through
strong air flow with Plasmacluster Ion.
When turned ON, it firstly starts ventilation for 10
minutes with maximum air flow, and then repeats
following operation.
(MOLD CONTROL Sign shows actual operating
mode. Purple: high air volume, Blue: low air
volume.)
It operates automatically the Plasmacluster Ion
"ON".
In a high humidity
It operates in "HIGH" mode of dehumidification
until the humidity of the room decreases to
the level which the mold less likely appears.
In a low humidity
Once the humidity in room becomes low, the
model switches the operation with maximum
airflow.
【 for about 80 minutes 】
(MOLD CONTROL Sign : blinking with Purple)
※ Operating time depends on the room environment,
usage conditions, and location of the Main Unit.
NOTE
• When the humidity becomes low, the main unit
operates with "Low" air flow.
(MOLD CONTROL Sign : lighting in Blue)
If the humidity becomes high again, it will switch to
the above operation under the condition of "in a high
humidity".