Dell G5 5000 Service Manual page 31

3. Remove the 3.5-inch hard drive.
About this task
The following images indicate the location of the power button and provides a visual representation of the removal procedure.
Steps
1. Lay the computer on the right side.
2. Disconnect the power-button cable from the system board.
3. Press the release tabs on the power-button module and push the power-button module out of the chassis.
4. Lift the power-button module, along with its cable, from the chassis.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button and provides a visual representation of the installation procedure.
Removing and installing components 31